Omron CRT1 - 10-2009, Operation Manual

Page: 86 / 675

62
Preparing Flat Connectors
Section 3-3
1,2,3... 1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
Note (1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
welding block.
(3) Set the connector in the correct orientation.
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
3-3-2 Flat Cable I
Preparing DCN4-TR4 Flat Connector Sockets
Component Names
Pliers Connector cover
OK
NG
NG
Be sure the connector is locked
on both the left and right sides.
Be sure there are no gaps here.
Cover Housing
Cable confirmation slot
Cable labels
(Flat cable: black, blue, white, and red)
Black