Omron CRT1 - 10-2009, Operation Manual

Page: 94 / 675

70
Preparing Flat Connectors
Section 3-3
Note When extending the cable or connecting it to a Terminating Resis-
tor, make sure that the end of the cable is inserted all the way to the
cable stopper so that it will not be pulled out.
■
Pressure-welding the Connector
Use the DWT-A02 Pliers to pressure-weld the connector.
1,2,3... 1. Set the connector on the pressure-welding block of the crimping tool.
As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Preparing DCN5-BR4 Flat Connector Plugs
Component Names
Connector position reference surfaces
Pliers
Connector cover
Be sure there are no gaps here.
Be sure that the connector is locked.
Cover