Omron CRT1 - 10-2009, Operation Manual

Page: 90 / 675

66
Preparing Flat Connectors
Section 3-3
■
Attaching the Cable
Align the cable labels and cable colors and insert the cable.
Confirm that the cable is inserted all the way to the back. (The cover is semi-
transparent.)
■
Crimping the Connector
Crimp the connector using the DWT-A01 Pliers.
1,2,3... 1. As shown in the following figure, align the center (see arrows) of the con-
nector cover with the center of the crimping block on the Pliers.
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
Note (1) Do not pressure-weld the connector cover at the edges.
(2) Do not pressure-weld the connector cover at the back of the pressure-
welding block.
(3) Set the connector in the correct orientation.
3. After attaching the cable, confirm that it is properly pressure-welded as
shown below.
Insert the cable to this point.
Pliers
Connector cover
OK
NG
NG
NG
Be sure there are no gaps here.