Omron CRT1 - 10-2009, Operation Manual

Page: 92 / 675

68
Preparing Flat Connectors
Section 3-3
Note After pressure-welding the cable, confirm that it has been pressure-welded
correctly. The tabs on the cover of the Housing must be completely locked.
3-3-3 Flat Cable II
Preparing DCN5-TR4 Flat Connector Sockets
Component Names
■
Cutting the Cable
Cut the cable perpendicular to the length.
To prevent short-circuits, cut the cable with a sharp blade, such as wire cut-
ters, and be sure that there are no whiskers on the wires.
■
Setting the Cable Stopper (when Extending Cable or Connecting a
Terminating Resistor)
A stopper must be set in advance when extending a line or connecting a Ter-
minating Resistor.
Set the cable into the cover and position it so that the cable end strikes the
cable stopper.
Pliers
Connector cover
Cover
Cable stopper