Omron CRT1 - 10-2009, Operation Manual

Page: 88 / 675

64
Preparing Flat Connectors
Section 3-3
2. Hold the cable and secure it with the hooks.
■
Line Extensions and Terminating Resistors
Insert the cable end all the way into a cover with the cable stopper already set.
■
Attaching the Housing
Confirm that the cable labels and cable colors match and then temporarily
secure the housing to the cover.
Note The housing cannot be removed from the cover once it has been
attached. The connector may be damaged if the housing is force-
fully removed.
■
Pressure-welding the Connector
The connector is pressure-welded using the DWT-A01 Pliers.
1,2,3... 1. As shown below, align the center (see arrows) of the connector cover with
the center of the pressure-welding block on the Pliers.
2. Squeeze firmly on the Pliers until the lock on the connector clicks into
place.
Location of cable stopper
Housing
Connector cover
Pliers