Omron CRT1 - 10-2009, Operation Manual

Page: 30 / 675

6
Features of CompoNet Slave Units
Section 1-1
Flat Cable Included
(Bit Slaves, except Bit
Slave Units with Compact
Connectors) Models of Bit Slave Units are available with a Flat Cable included (standard or
sheathed). Models with a Flat Cable included, however, do not support a baud
rate of 4 Mbps. (Branching is not possible.)
No I/O Power Supply
Wiring Required
(Bit Slaves) External I/O (sensors or actuators) connected to Bit Slaves using e-CON con-
nectors, clamp terminals, or compact connectors are supplied power from the
CompoNet communications power supply. No separate wiring is required for
I/O power supply.
Industry Standard Sensor
e-CON Connectors
(CRT1-V
@
D08S(-1)/
CRT1- @ D @ S(-1)/
CRT1-
@
D16SH(-1)/
CRT1B-
@
D02S(-1)/
CRT1B- @ D0 @ SP(-1)/
CRT1-VAD04S/
CRT1-VDA02S)
No special tools are required for connections because industry standard e-
CON connectors are used. Electrical cables do not need to be stripped and
are simply inserted with pliers. When using e-CON connectors, there is no
need to prepare special tools for wiring, and connectors from different makers
can be used interchangeably.
Units with MIL Connectors
(CRT1-V
@ D @@ ML(-1)/
CRT1-VAD04ML/
CRT1-VDA02ML)
MIL connectors, widely used in the electronic components and semiconductor
industries, help reduce wiring requirements.
Units with Clamp Terminal
Blocks
(CRT1-
@ D @@ SL(-1)/
CRT1B-MD04SLP(-1))
There is no need to tighten the screws because these Units use screw-less
clamp terminal blocks. Connections are made simply by inserting the pin ter-
minals. Wiring can be completed in one step.