Omron CRT1 - 10-2009, Operation Manual

Page: 370 / 675

346
Units with Connectors
Section 6-7
Indicator Section
Communications
Indicators Refer to 4-1-3 Communications Indicators .
Switch
Setting the Node Address The node address is set as a decimal number with the 10s digit set on the left
rotary switch and the 1s digit set on the right rotary switch. (The maximum
node address is 63.)
Rotary switch settings are read when power is turned ON.
Output range switch
Note (1) Always use the default setting (OFF) for pin 7.
(2) Always set pin 8 to ON if the DIP switch is used to set the ranges. If this
pin is OFF, the DIP switch settings will not be enabled.
(3) The DIP switch settings are read when power is turned ON.
0
1
23
4
5
6
7 8 9
0
1
23
4
5
6
7 8 9
1s digit of node address
10s digit of node address
(Front side)
(Mounted side)
Pin No. Setting Specification
1 Range settings for output
CH0 See the next table
Default setting: All pins OFF
2
3
4 Range settings for output
CH1 See the next table
Default setting: All pins OFF 5
6
7 Always OFF. Always set this pin to OFF. Malfunctions may
occur if it is set to ON.
8 Range setting method OFF: Use CX-Integrator.
ON: Use DIP switch.
8
7
6
5
4
3
2
1
ON
(Front side)