Omron CRT1 - 10-2009, Operation Manual

Page: 410 / 675

386
Temperature Input Units
Section 7-5
CRT1-TS04P
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
Note 1. Always set pin 5 and pin 7 to OFF (default).
2. Always set pin 8 to ON if the DIP switch is used to set the ranges. If this pin
is OFF, the DIP switch settings will not be enabled.
3.
The DIP switch settings are read when the power is turned ON.
4.
°
C/
°
F display settings cannot be set individually for each input.
Setting Using the CX-
Integrator Input types can be set for each temperature input using the CX-Integrator.
Use the following procedure.
1,2,3... 1. Turn ON the power supply to the Temperature Input Unit.
2. Double-click the icon of the Temperature Input Unit to be set in the Network
Configuration Window or right-click the icon and select
Parameter - Edit .
The Configuration Window will be displayed.
3. Click the tab for the input where the input type is to be set and select an
input type in the
Input Type Field.
4. Return to the General Tab Page, click the Transfer [PC to Unit] Button to
download the data, and then click the Reset Button to reset the Unit.
5. Click the OK Button and exit the window.
Temperature Ranges
by Input Type
The following tables show the temperature ranges for each input type.
CRT1-TS04T
SW1 SW2 SW3 SW4 Input type
Always
OFF OFF Always OFF. PT100 (
−
200 to 850
°
C)
ON PT100 (
−
200 to 200
°
C)
Input type Temperature range (°C) Temperature range (°F)
R 0 to 1,700 0 to 3,000
S 0 to 1,700 0 to 3,000
K (
−
200 to 1300
°
C)
−
200 to 1,300
−
300 to 2,300