Omron CRT1 - 10-2009, Operation Manual

Page: 409 / 675

385
Temperature Input Units
Section 7-5
Setting the Input Type
Setting with the DIP
Switch The input type can be set using the DIP switch or the CX-Integrator.
Set each pin according to the following table.
CRT1-TS04T
Note If the settings are incorrect, the MS Indicator will flash red and the
Unit will not operate. In this case, make the settings again and reset
the power supply.
Pin No. Setting Specifications
SW1 Sets the input type (input
range) Refer to the following table.
Default setting: All pins OFF
SW2
SW3
SW4
SW5 Always OFF Always set this pin to OFF. Malfunctions may
occur if it is set to ON.
SW6 Selects °C or °F display. OFF: °C conversion
ON: °F conversion
Default setting: OFF
SW7 Always OFF Always set this pin to OFF. Malfunctions may
occur if it is set to ON.
SW8 Selects the input type set-
ting method. OFF: Set with CX-Integrator.
ON: Set with DIP switch.
Note When the input type is set with the DIP
switch, all inputs are set to the same
input type. To set different input types,
use the CX-Integrator to make the set-
tings.
SW1 SW2 SW3 SW4 Input type
OFF OFF OFF OFF R
ON OFF OFF OFF S
OFF ON OFF OFF K (
−
200 to 1300
°
C)
ON ON OFF OFF K (0.0 to 500.0
°
C)
OFF OFF ON OFF J (
−
100 to 850
°
C)
ON OFF ON OFF J (0.0 to 400.0
°
C)
OFF ON ON OFF T
ON ON ON OFF E
OFF OFF OFF ON L (
−
100 to 850
°
C)
ON OFF OFF ON L (0.0 to 400.0
°
C)
OFF ON OFF ON U
ON ON OFF ON N
OFF OFF ON ON W
ON OFF ON ON B
OFF ON ON ON PL2
ON ON ON ON Not used.
1 2 3 4 5
6
7 8
ON