Omron CRT1 - 10-2009, Operation Manual

Page: 137 / 675

113
Connecting External I/O for Slave Units
Section 3-6
Installation Method
1,2,3... 1. Expand the split in the sealing piece and insert the cable.
2. Place the groove on the sealing pieces onto the inside of the housing to
secure it. (See following diagram.)
Handling
Unconnected
Terminals
For terminals that are not connected, insert an NC pin into the small cable
sealing piece as shown in the following diagram. Then secure the sealing
piece onto the housing as described above.
Tightening the Cover
Finally, close the cover and tighten the cover screws.
The tightening torque is 0.8 to 1.0 N·m.
3-6-6 Connecting to Compact Connectors
The compact connectors use XA-series Connectors from JST Mfg. Co., Ltd.
Special cable connectors must be attached for cables connecting to external
devices if a Slave Unit with Compact Connectors is used.
XA-series Connectors
from J.S.T. Mfg.
Name Applicable cable range Model Crimping
Tool
mm
2 AWG# Wire sheath
external
diameter
Contacts 0.08 to 0.33 28 to 22 1.2 to 1.9 SXA-001T-P0.6 YC692 or
YC692R
0.22 to 0.5 24 to 20 1.5 to 1.9 SXA-01T-P0.6 YRS701 to
YC701R