Omron CRT1 - 10-2009, Operation Manual

Page: 91 / 675

67
Preparing Flat Connectors
Section 3-3
Preparing and Connecting DCN4-MR4 Multidrop Connectors
Componet Names
■
Wiring Procedure
1,2,3... 1. Align the line colors of the cable with the cable labels, and place the cable
on the Connector.
2. Close the cover until the hooks lock in place.
■
Attaching the Housing
1,2,3... 1. Confirm the colors again, and temporarily secure the housing to the cover.
■
Pressure-welding the Connector
Use the DWT-A01 Pliers to pressure-weld Connector.
1,2,3... 1. As shown in the following figure, set the connector cover so that the center
of it (indicated by the arrows) is in the center of the pressure-welding block
of the Pliers.
2. Squeeze the Pliers firmly until you hear the connector lock into place.
Cover Housing
Cable labels (Black,
blue/green, white, and red)
Black
Cable Attached to
Connector