Omron CRT1 - 10-2009, Operation Manual

Page: 74 / 675

50
Installing Slave Units
Section 3-1
Installation
Orientation
1,2,3... 1. Hook the slot on the back of the Unit into the top of the DIN Track. Pull
down the DIN Track mounting pin and insert the Unit.
2. Hook the bottom of the End Plate on the DIN Track first, and then the top.
Attach an End Plate on each side of the Unit, and tighten the screws to se-
cure them. Check to make sure that the Unit is firmly secured.
3-1-4 Mounting with a Mounting Bracket
Slave Units with e-CON connectors (CRT1-V @ D08S(-1)/CRT1-VAD04S/
CRT1-VDA02S) or MIL connectors (CRT1-V @ D @@ ML(-1)/CRT1-VAD04ML/
CRT1-VDA02ML) can be panel-mounted or wall-mounted, either vertically or
horizontally, using special Mounting Brackets.
Required Brackets
DIN Track
DIN Track mounting pin
End Plate
Name Model Applicable Slave Unit
Mounting Bracket CRT1-ATT01 Units with MIL Connectors
CRT1-V
@
D16ML(-1)
CRT1-VAD04ML
CRT1-VDA02ML
CRT1-ATT02 Units with e-CON Connectors
CRT1-V
@
D08S(-1)
CRT1-VAD04S
CRT1-VDA02S
SRT2-ATT02 Units with MIL Connectors
CRT1-V @ D32ML(-1)