Omron CRT1 - 10-2009, Operation Manual

Page: 136 / 675

112
Connecting External I/O for Slave Units
Section 3-6
Note Press the release button with a force of 30 N or less. Applying excessive force
may damage the clamp terminal block.
3-6-5 Connecting External I/O to IP54 Bit Slave Units
Components
External I/O is connected to e-CON connector terminals or screw-less clamp
terminals inside the housing. Connected external I/O cables are passed
through the sealing.
The cables are held between the sealing section cover and sealing section
housing to ensure resistance to splashing.
For cables with smaller outer diameters, the sealing pieces can be used to
ensure splash resistance.
Applicable Cables
The range of outer diameters of cables that can be connected is 2.2 to
6.3 mm. When the diameter is within the range of 2.2 to less than 3.6 mm,
then the sealing section for small-diameter cables must be attached.
3.5 mm 0.6 mm
Side Front
Sealing section cover
Cover screws
Cover
NC pin
Small cable sealing pieces
Housing
Sealing section housing
Split