Omron CRT1 - 10-2009, Operation Manual

Page: 439 / 675

415
Bit Slave Units with e-CON Connectors
Section 9-3
9-3-2 Two-point Output Units
CRT1B-OD02S/CRT1B-OD02S-1
Output Section Specifications
Note The current consumption is for Bit Slave Unit communications cur-
rent when all outputs are OFF, i.e., it does not include the output de-
vice load current consumption. The communications power supply
is also used for the I/O power supply for actuators. Be sure to con-
sider the actuator load current consumption and the number of sen-
sors connected in addition to the communications power. The
power supply current consumption is expressed by the following
formula.
Communications power supply current consumption = Bit Slave
Unit communications current consu (actual load current
×
number of actuators used)
Item Specification
Model CRT1B-OD02S CRT1B-OD02S-1
I/O capacity 2 outputs
Internal I/O common NPN PNP
Rated output current 0.2 A/output
Load power supply voltage Communications power supply voltage 0 V (max.)
Communications power supply voltage
−
1.2 V (min.)
Residual voltage 1.2 V max. (0.2 A DC, between each
output terminal and BS
−
)
1.2 V max. (0.2 A DC, between each
output terminal and BS+)
Leakage current 0.1 mA max.
ON delay 0.5 ms max.
OFF delay 1.5 ms max.
Number of circuits per com-
mon 2 outputs/common
Load short-circuit detection Supported.
Isolation method No isolation
Output indicators LEDs (yellow)
Degree of protection IEC standard IP20
Installation Screw installation (M4)
Power supply type Network power supply
Communications power sup-
ply current consumption (See
note.) 55 mA max. for 24-VDC power supply
voltage
75 mA max. for 14-VDC power supply
voltage
55 mA max. for 24-VDC power supply
voltage
70 mA max. for 14-VDC power supply
voltage
Weight 59 g max.