06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
132
Sensor adjust
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Parameter only appears in production mode.
For detailed instructions sensor adjustment, please refer to the service
manual, topic section "Service Electronics", paragraph "Settings".
Sensor test
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
The description of the sensor test can be found in the printer service manual,
topic section „Service Electronics“, chapter
Sensor test
.
The values displayed are for checking the sensors (sensor check) and can
by adjusted by service personnel.
Cutter test
64-xx
Makes it possible to test the cutter function without having to set the para-
meter
SYSTEM PARAMETER > Periph. device
to „cutter“.
Press Cut Key
Triggers a cut, if a cutter is installed. Without a cutter nothing will happen.
Matend tolerance
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Material end tolerance
This is relevant for label stock with very long punches. To avoid those punch-
es being recognized as material end by mistake, can here the distance be
set, after which the gap over the light sensor is interpreted as material end.
By choosing a very high material end tolerance, you loose the protection
of the print roller against being printed on!
xxx mm
Setting range: 20-300 mm; Default setting: 35 mm
Feedadjust label
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Prints a scale, which enables to calculate the feed adjust value (see next
parameter).
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter
Adjusting the imprint position
.
