06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
74
Latest dottest
64-xx
ALX 92x
DPM
PEM
Only if
SYSTEM PARAMETER > Autom. dot check
= „Continuous“.
Determins the number of printed labels, after which the dot check must be fin-
ished.
Example:
The setting 5 means that the dot check has to be finished at the latest after
the fifth printed label. If necessary, printing is interrupted after the fifth label.
After a successfully proceeded dot check has the next dot check again to be
finished after five labels.
after x label
Setting range: 1 to 9999; Unit interval: 1; default setting: 0
The setting "after 0 label" means, that the dot check will possibly be never
finished! – given a high utilization of the printer (A printing pause will never
be forced).
The value for "Latest dottest" must be set higher than the value for "Early
dottest"! (exception: value 0).
Dottestarea from
64-xx
ALX 92x
DPM
PEM
Only if
SYSTEM PARAMETER > Autom. dot check
= „Continuous“.
Limitates the area of a print head, in which the dots are checked. The param-
eter sets the lower border of the dot check area. The value equals the dis-
tance to the left print head end in mm, looked at the print head from above
(see Fig. 13).
x mm
Setting range: refer to Tab. 3; Unit interval: 1; default setting: 0 mm
Printer type
Setting range in mm
No. of dotss
64-04 / Chess 4
0-107
1280
64-05 / Chess 5
0-128
1536
64-06 / Chess 6
0-160
1920
64-08 / Chess 8
0-214
2560
[6]
Setting range for the dot check, depending on the print head width. Right column: Total
number of dots of the print head.