06/15 Rev. 10
USER + SERVICE MANUAL
/Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
16
1101 Wrong
time/date
Status
Easy-Plug command #RTC (set realtime clock): unvalid date or wrong
date/time format.
Measure
Check command #RTC in the current printjob.
Please read the notes in section
Easy-Plug errors
.
1110 Opening
Bracket
Status
General software error
Measure
Switch printer off and then back on again after thirty seconds.
Please read the notes in section
General software errors
.
1111 Closing
Bracket
Status
General software error
Measure
Switch printer off and then back on again after thirty seconds.
Please read the notes in section
General software errors
.
1112
Para: No Value
Status
General software error
Measure
Switch printer off and then back on again after thirty seconds.
Please read the notes in section
General software errors
.
1113
No Default Value
Status
General software error
Measure
Switch printer off and then back on again after thirty seconds.
Please read the notes in section
General software errors
.
1114
< Limit value
Status
A sent Easy Plug command contains a value which exceeds the admissible
range at the bottom limit. The faulty value is replaced automatically by a
default value matching the limits.
Example: #YT109/-1/. The value –1 has been assigned to the parameter d.
Admissible for d are the values 0, 1, 2, 3. Therefore, -1 exceeds the value
range at the bottom limit.
Measure
Check the Easy Plug command on admissible values and correct them if
necessary.
Please read the notes in section
Easy-Plug errors
.
