06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
92
DISPENSER PARA
This menu appears only, if
SYSTEM PARAMETER
> Periph. device
is set to
„Dispenser“.
Head disp dist.
(Distance printhead - dispensing edge)
ALX 92x
DPM
xxx,x mm
Setting range: 10.0 to 200.0 mm; Step width: 0.1 mm; Default setting: 20 mm
Dispense Mode
64-xx
ALX 92x
DPM
Governs the run of the print-dispense procedure.
Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
Dispense only
With this setting, the printer can be used as a mere dispenser without pro-
cessing print jobs. Set the material length before you use this function.
See parameter
PRINT PARAMETERS > Material length
.
After calling "Dispense only", the printer restarts; afterwards, the following is
displayed:
The parameters menu can be activated as usual after having switched to the
offline mode by pressing the Online button two times.
Normal 1:1 Mode
•
The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
•
The label is being dispensed while printing.
•
The output volume is at its maximum level.
The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25 mm) + Dispense position
(tab. 10)
Also refer to parameter
PRINT PARAMETERS > Dispense position
.
A graphic can be found under
PRINT PARAMETERS > Cut mode > Normal 1:1 mode
.
Dispense only
Labels 0
0 = Number of dispensed labels.
Printer
Distance print line - dispensing edge
64-xx
39.8 mm (long dispensing edge)
24.2 mm (short dispensing edge)
AP 5.4
25.0 mm
[10] Distances between print line and dispensing edge for some printers.