06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
133
Feed adjust
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Corrects the material feed length. Such a correction can be necessary when
printing on very long labels, to compensate slippage-related feeding inaccu-
racy.
For application instructions, refer to the Service Manual, topic section
„Electronics Gen. 3“, chapter
Adjusting the imprint position
.
x.x% [ribbon]
Setting for
thermal transfer printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%
Only appears if thermal transfer printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon.
)
x.x% [direct]
Setting for
thermal direct printing
Setting range: -10.0 to +10.0; Step width: 0.1%; Default setting: 0%
Only appears if thermal direct printing was selected (see
SYSTEM
PARAMETER > Ribbon autoecon.
)
Punch y calibr.
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Only in production mode
Compensating the variation of distance between punch sensor and thermal
bar of the printhead.
x.x mm
Setting range: -3.0 to 3.0; Default setting: 0.0; Unit interval: 0.1
Foil feed adjust
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Only in production mode.
Modifies the foil feed speed in comparison to the material feed speed.
xx,x %
Setting range: -20.0 to 20.0; Default setting: 0.0
•
Decreasing the setting: Foil transport gets faster
•
Increasing the setting: Foil transport gets slower
Punch y calibr
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Only in production mode.
Compensating of variations between the label sensor and the thermal bar at
the printhead.
x.xmm
Setting range: -3.0 to 3.0; Default: 0.0; Step width: 0.1