06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
40
PRINT PARAMETERS
Print speed
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
The print speed (material feed) can be adjusted according to the ribbon and
material combination being used in order to optimise the contrast depth and
the density of the print image.
x inch/s (mm/s)
Setting range: see table (tab. 3); Unit interval: 1 inch/s (5 mm/s)
Default setting: 8 inch/s
DPM / PEM / ALX 92x / ALX 73x (PMA): Print speed can be set optionally
in Inch/s or mm/s. The unit is selected with
SYSTEM PARAMETER > Speed unit.
Feed speed
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Setting:
The value for the feed speed should not be set too high for print applications
with long calculating units (e. g. consecutive numbering). This can help to
avoid alternating between abrupt braking to 0 (zero) and acceleration to print
speed.
When altering the print speed, the feed speed is equal to the print speed.
If a different feed speed is required, this must be set again.
x inch/s (mm/s)
Setting range: see table (tab. 3); Unit interval: 1 inch/s (5 mm/s)
Default setting: 8 inch/s
DPM / PEM / ALX 92x / ALX 73x (PMA): Print speed can be set optionally
in Inch/s or mm/s. The unit is selected with
SYSTEM PARAMETER > Speed unit.
Printer
Print speed / feed speed
(mm/s)
(Inch/s)
64-04/05
2-16
6406
2-14
64-08
2-9
ALX 924/5, DPM 4/5“, PEM 4/5“,
ALX 734/5 (PMA)
50-400
2-16
ALX 926, DPM 6“, PEM 6“,
ALX 736 (PMA)
50-300
2-12
[3]
The setting range of the print/feed speed depends on the printer type.
