06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
130
yes
Increases the counter "Cutter number" by one
no
Doesn´t increase the counter
Serv. data reset
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Parameter only appears in production mode.
Sets all counters on the info printout „Service Status“ to zero.
See parameter
Service Status
on page 36.
Head dot test
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
Checks the print head for defective dots. The test ends with a status
printout [20], listing the defective dots. The printout is also made without hav-
ing found any defective dots.
During the test appears the display:
The printout requires 100 mm wide and 200 mm long label material.
[20] Status printout after successfully proceeded dot check. Upper section: technical data of
the print head; Lower section: list of defective dots.
CAUTION!
Risk of printhead damage.
Never switch off the printer while the dot check is running. If not observed,
dots of the print head can be damaged.
Head dot test
running ...
