06/15 Rev. 6.01-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
13
Material light barrier
The series 64-xx printers are fitted with transmitted-light light barriers.
Reflector light barriers are also available as an option.
To set
Setting is performed by means of the red rotary knob (1) on the outside
of the print module. The light barrier can be adjusted in a range of 15 mm
transverse to the material by turning the rotary knob. A dial (2) shows the
setting value from 0 to 15.
[1] The red adjusting knob (1) is used to adjust the lateral position of the punch light bar-
rier (figure: dispenser version).
Setting value
[2] Punch position = distance of punch center from (inner) edge of material (3).
To set, turn the rotary knob (1) until the desired setting value is opposite
the marking.
Example
(for transmitted-light light barriers) center of punch from left edge =
11 mm, from which 2 mm deducted, giving a setting value of 9 mm.
For round labels, it is possible to perform a preliminary setting of the
punch offset manually on the printer (parameter
PRINT PARAMETERS > X –
print offset
) or by activation in order to capture the start of the labels
correctly.
Light barrier
Setting value =
Transmitted light Punch position - 2 mm
Reflector
Punch position - 13 mm
[Tab. 1]
How to determine the setting value for the punch light barrier. (Punch position
= distance of punch center from (inner) edge of material (3); setting value =
dial value to be set by turning the red wheel)
