06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
124
Printhead type
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
This parameter is only visible in production mode!
This parameter chooses the applied printhead type. In most cases equals
the printhead width the maximum printwidth of the printer. This parameter is
called automatically, after you have modified the printer type setting
(
SPECIAL FUNCTION > Printer type
).
KCE 8Inch
Printhead Kyocera KCE, 8" width, is applied in the following printer type:
64-08
KCE 6Inch
Printhead Kyocera KCE, 6" width, is applied in the following printer types:
64-06, DPM 6“, PEM 6“, ALX 926
KCE 5Inch
Printhead Kyocera KCE, 5" width, is applied in the following printer types:
64-05, DPM 5“, PEM 5“, ALX 925, PM 3000
KCE 4Inch
Printhead Kyocera KCE, 4" width, is applied in the following printer types:
64-04, DPM 4“, PEM 4“, ALX 924
Sensor type
PEM
ALX 73x (PMA)
Only in production mode.
Combined sensor
Required setting, if the printer is equipped with a combined reflex/punch
sensor.
Standard
Required setting, if the printer is equipped with separate light sensors for
reflex marks or gaps.
Disp. Head Offs.
64-xx
Only with 64-xx dispenser equipped with a 4“ printhead.
Only in production mode.
Dispenser Head Offset
Yes
Setting required for 64-04 dispenser with 4“ printhead: At the inner side end
of the printhead exists a non-printable area of 13 mm width.
No
Setting required for 64-05 dispenser with 4“ printhead: Full 4“ print width with-
out restrictions. Precondition: The printhead is positioned at least 13 mm
away from the innner side printhead end.