06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
84
Periph. device
64-xx
ALX 92x
DPM
PEM
ALX 73x (PMA)
After installation, options must be selected under "Peripheral device" in order
to be assured of the corresponding sensor queries and printer reactions.
None
No peripheral device is installed.
Cutter
Sets the printer firmware to the cutter option. Selection permits access to the
cut parameters.
Rewinder
Sets the printer firmware to the rewinder option. Selection permits access to
the rewinder setting parameters.
Tear-off edge
Sets the printer firmware to the tear-off edge option. The punch is fed forward
to the tear-off edge.
Dispenser
Setting for 64-xx dispenser version.
64-04/05 only: After selecting this value, the parameter
SPECIAL FUNCTION >
Disp. Head Offs.
appears automatically, if the parameter
SPECIAL FUNCTION >
Printhead type
is set to „KCE 4 Inch“.
See parameter
Disp. Head Offs.
on page 124.
See parameter
Printhead type
on page 124.
Disp. with LTSI
Setting for operation of a LTSI applicator, see
Technical Manual LTSI
Singlestartquant
64-xx
ALX 92x
DPM
PEM
Determines the label quantity, which will be printed after a start signal.
xx
Setting range: 1 to 10; Unit interval: 1; Default setting: 1
Head disp dist
(Distance printhead - dispensing edge)
64-xx
ALX 92x
DPM
64-xx: 64-xx dispenser only and only with
SYSTEM PARAMETER
>
Dispensing edge = „User defined“
For setting the distance between printhead and dispensing edge.
xxx.x mm
Setting range: 10.0 to 100.0 mm; Unit interval: 0.1 mm; Default setting: 20
mm
CAUTION!
Selecting an incorrect option can lead to malfunctions or damage.
