06/15 Rev. 6.00-02
USER- / SERVICE MANUAL
Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
96
The setting "Light barrier" is unsuitable for product sensors! Product
sensors must be connected to the I/O board!
Dispensing edge
64-xx
Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
Adapts the feeding to the length of the dispensing edge.
long
Long dispensing edge
short
Short dispensing edge (Default setting)
User defined
The distance between print line and dispensing edge can be set by
SYSTEM PARAMETER > Head disp dist
(see below). This is helpful if none of the
standard dispensing edges are applied.
Max InitFeedback
64-xx
ALX 92x
DPM
64-xx: Only with dispenser version.
Only if
SYSTEM PARAMETER > Gap detect mode
= „Autom. feed back“.
During initialization, the label material is fed back until the next punch/reflex
mark is reached. This parameter defines the maximum admissible back-
wards feeding length.
xx mm
Setting range: 0 to 200 mm; Step width: 1 mm; Default setting: 80 mm
Transport mode
64-xx
Only if
SYSTEM PARAMETER > Periph. device
= „Dispenser“.
In normal operation mode, the rewinder motor (Dispenser Motor) feeds the
material, while the feed motor runs idle. When applying very slim material, it
can be advisable to add the power of the feed motor in order to prevent ma-
terial rupture (Dual Motors). To run the printer like a usual non-dispenser, the
rewinder motor can be switched off (Printer Motor).
Absolutely use the "Dual Motors" mode, if the following three conditions
are the case:
•
Printer is used as dispenser
•
Ribbon autoeconomy mode switched on
•
Print speed higher than 203 mm/s (8 inch/s)
Printer Motor
Rewinder motor switched off. The printer behaves like a model without dis-
penser option.
Dual Motors
Both motors (feed and rewinder) are activated.
Dispenser Motor
The feed motor is switched off. The rewinder motor feeds the material (De-
fault setting).
