06/15 Rev. 10
USER + SERVICE MANUAL
/Status Reports
64-xx – DPM – PEM – ALX 73x (PMA) – LPA 81x (Printer) – ALX 92x – AP 5.4 – AP 5.6
52
5131 PSU
communicat.
Power supply communication
(64-xx / DPM / PEM / ALX 92x / PM 3000 only)
Status
A fault occured during communication with the power supply via I
2
C bus.
Measure
Switch the printer off and after 30 seconds on again. If the message
continues to appear, contact the manufacturer.
5140 Rewinder
control
(ALX 92x with M5A motor output stages only)
During problem-free operation, the rewind unit dancer arm only moves
a minimal distance around the "control position". This is the position
the dancer arm takes up after initialisation of the machine.
Status
Cause
: Any force applied that moves the dancer arm from its control
position.
Example: The feed motor is blocked; the backing paper is not conveyed
quickly enough; as a result the dancer arm is pulled upwards.
Example: The backing paper is torn; the dancer arm springs downwards.
Measure
Press the Enter-key.
This reinitialises the dancer arm control; the dancer arm moves back into
the control position.
5144 Rewinder
Init
(ALX 92x with M5A motor output stages only)
Status
The message has a couple of possible causes:
•
No label material inserted.
•
Rewinder sensors are not or not pro-perly connected.
•
Sensor board position is faulty.
•
Sensor defective.
Insert material.
Check the connection. Connect the sensors properly.
Correct the position of the sensor board.
Exchange the sensor board.
5145 Rewinder
full
(ALX 92x with M5A motor output stages only)
Status
The maximum permitted diameter (205mm) for the rewinder roll has been
reached.
This error can only occur if the end of a new label roll was glued on to
backing paper that had already been wound onto the rewinder.
Measure
Remove the rewound backing paper.
Press the Enter-key to confirm the error message.
