10/14 Rev. 03
USER/SERVICE MANUAL
Technical Data
64-xx Gen. 2/3
2
64-0x Dispenser M
•
Basic equipment as 64-0x Peripheral
•
Additional features: Dispensing edge and internal backing paper rewinder
•
Dispensing of self-adhesive labels after printing; the backing paper is wound up
inside of the printer.
•
„M“ stands for manual application of the labels, what means that the label is taken
off the dispensing edge and is applied to the product by hand. For this reason, the
dispensing edge provides a light barrier which triggers the dispensing of the next
label, if the current one is taken off.
Alternatively, the dispensing can be triggered by a foot switch. The switch must
be connected to the
optional
single-start connector.
64-0x Dispenser A
•
Basic equipment as 64-0x Peripheral
•
Additional features: Dispensing edge and internal backing paper rewinder
•
Dispensing of self-adhesive labels after printing; the backing paper is wound up
inside of the printer.
•
“A” stands for automatic label application, what means, that the label is applied by
an applicator. The dispensing edge is longer than the type “M” edge and has no
light barrier.
Options 64-0x Gen. 2
Internal Options
...should be factory-fitted or installed by a service engineer:
•
Reflex sensor
: Light barrier fork that apart from the transmission sensor, also con-
tains a reflex sensor.
•
Fullsize sensor
: Punch sensor which can be shifted across the full material width.
The fullsize sensor can not be used under one of the following conditions:
– The printer is a 64-0x Dispenser (type A or M).
– The printer is operated with the online verifier (see below) option.
•
USI
(Universal Signal Interface): can e.g. be used to control an applicator or a
scanner.
•
Options board
with an additional serial interface (COM 2) and a PS/2 keyboard
connector.
•
Antistatic kit
: reduces electrostatic charge, which can especially arise of the pro-
cessing of plastic labels. Electrostatic discharge can damage or destroy electronic
circuits of the printer.
•
Realtime clock
•
Single-Start option
: Connector for a foot switch or another external signal, which
is supposed to start or stop the printer.
External Options
…do not require any special alterations to the printer, however, the printer must be
prepared for the use of peripheral devices:
•
Cutter
: Optional high-performance, low-noise cutter with double-cut function from
1 to 5 mm
•
Rewinder
: is mounted to the printer and rewinds the printed label materials with
the printed side facing inwards or outwards