06/15 Rev. 6.01-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
5
Inserting material
•
64-xx: Steps 1 to 8
•
64-xx dispenser: Steps 1 to 18
1. Open the hood of the unit.
2. Pull off the outer guide disk (1) of the
unwinder (2).
3. Creel material on the unwinder with the
corresponding adapter rings. The roll of
material should turn anti-clockwise when
unwinding.
4. Refit the outer guide disk of the unwinder.
5. Lay material around the dancer arm.
6. Set the material guide to the width of the
label material. To do this, loosen the
knurled screw on the underside of the front
material guide (3). Push the material guide
sideways. Tighten the knurled screw again
(Fig. 2).
7. Press the red opener (4) of the intake in
order to raise the pad rollers. With the
opener depressed, push the start of the
material through the material guide until it
is below the print head (Fig. 3).
8. Align the material so that it is taken in
straight. With the loading lever depressed,
position the pad rollers of the printing unit
in such a way that both rollers (5) sit sym-
metrically on the material. (The print head
has been removed in Fig. 4 to allow a bet-
ter view).
CAUTION!
Rotating axles! These can pull
in and tear off hair, clothing
and jewelry.
– Do not operate the machine with
the hood open!
– Keep long hair, loose clothing,
jewelry etc. well away from the
machine!
1
2
3
4
