Novexx Solutions 64-04, User Manual

Page: 159 / 438

06/15 Rev. 6.00-02 USER- / SERVICE MANUAL Info-Printouts & Parameters
64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
42
Print direction
64-xx ALX 92x DPM PEM ALX 73x (PMA)
[9] Orientation of the printout „Foot first“ (A) or „Head first“ (B).
Foot first
(Default) Orientation of the printout according to [9A].
Head first
Orientation of the printout according to [9B]. Mind the following:

Define the „true“ label length (without gap length) in parameter
PRINT
PARAMETERS > Material length . If the label gap is wider than 5 mm, the parameter
SYSTEM PARAMETER > Miss. label tol.
must be set to a value more than zero.

The distance between material base line and the first printable dot is
1 mm. To keep this distance while printing „head first“, the material width
must be calculated as follows::
, with
b
Mat
: Material width
b
Bp
: Backing paper width
Punch offset
64-xx ALX 92x DPM PEM ALX 73x (PMA)
The zero position can be determined offset in millimetre units from the detect-
ed gap position.

The value is overwritten by the appropriate Easy Plug command when
sending label formats.
xxx mm Setting range: -8 to +max. label length; Unit interval: 0,1mm
Default setting: 0 mm
Maximum offset in feed direction: -8 mm
Minimum offset against feed direction: +max. label length
A B
Printer
Printout
b
Mat
b
Bp
2 mm – =