06/15 Rev. 6.01-01
USER MANUAL
Einrichten
64-xx – 64-xx dispenser
14
Print head contact pressure
Different material widths and/or material
thicknesses have an effect on the contact
pressure of the thermal strip on the feed
roller.
The contact pressure can be set in 3 steps:
I
Position for 64-04/05 or for thin/narrow
material up to the maximum print width of
the 64-05 (1)
II Position for 64-06 or for average material
up to the maximum print width of the
64-06 (2)
III Position for 64-08 or for thick/wide mate-
rial up to the maximum print width of the
64-08 (3)
To set:
The red adjusting screw (4) sits above the
ribbon roller and can be turned by means of
a coin.
For medium head contact pressure, turn
the arrow to position II until it engages.
For greater head contact pressure, turn the
arrow to position III until it engages.
Always choose the lightest contact
pressure that will produce an acceptable
printing result. This will help to protect the
print head and the entire unit.
Excess contact pressure
can lead to premature wear on
the print head.
Factory setting:
Position 1, thin/narrow material
1
2
