Keysight Technologies E5260 Series, Programming Manual

Page: 297 / 350

Keysight E5260/E5270 Programming Guide, Edition 4 4- 113
Command Reference
Command Reference
TGMO
The TGMO command selects the edge trigger or the gate trigger for the Step
Measurement Completion trigger output set by the
TGP
port
,2,
polarity
,3
command. See Figure 4-2 .
This command is available for the staircase sweep and multi channel sweep
measurements.
Syntax
TGMO mode
Parameters
mode : Edge trigger or gate trigger. Integer expression.
1: Edge trigger (initial setting).
2: Gate trigger.
Example
Statements
OUTPUT @E5270;"TGMO 2"
See Also “TGP” and “TGPC”
Figure 4-2 Trigger Output Example, Staircase Sweep Measurement, Negative Logic
: Measurement
TGP t,2,p,3
XE
TGP t,2,p,2
TGP t,2,p,1
TGP t,2,p,3
TGP t,2,p,2
TGP t,2,p,1
Gate trigger
Edge trigger
Source trigger delay
Hold time
Delay time
Source trigger delay
Step delay time
Step Measurement Completion
Step Output Setup Completion
Measurement Completion
Step Measurement Completion
Step Output Setup Completion
Measurement Completion