Keysight Technologies E5260 Series, Programming Manual

Page: 252 / 350

4- 68 Keysight E5260/E5270 Programming Guide, Edition 4
Command Reference
Command Reference
30 : Returns the filter ON/OFF status:
FL0 [ off ch [, off ch . . . [, off ch ] . . . ];
FL1 [ on ch [, on ch . . . [, on ch ] . . ] <CR/LF^EOI>
If all modules are Filter OFF, the query response is:
FL0<CR/LF^EOI>
If all modules are Filter ON, the query response is:
FL1<CR/LF^EOI>
31 : Returns the parameter values of the TM, AV, CM, FMT, and MM
commands:
TM trigger mode ;AV number [, mode ];CM auto calibration mode ;
FMT output data format , output data mode
[;MM measurement mode [, chnum [, chnum ...[, chnum ]...]]]
<CR/LF^EOI>
32 : Returns the measurement ranging status:
RI chnum , Irange ;RV chnum , Vrange
[;RI chnum , Irange ;RV chnum , Vrange ]
:
[;RI
chnum , Irange ;RV chnum , Vrange ]<CR/LF^EOI>
33 : Returns the staircase sweep measurement settings:
WM automatic sweep abort function , output after sweep ;
WT hold time , delay time [, step delay time [, S trig delay [, M trig delay ]]]
[;WV chnum , mode , range , start , stop , nop [, Icomp [, pcomp ]]] or
[;WI chnum , mode , range , start , stop , nop [, Vcomp [, pcomp ]]]
[;WSV chnum , range , start , stop [, Icomp [, pcomp ]]] or
[;WSI chnum , range , start , stop [, Vcomp [, pcomp ]]]<CR/LF^EOI>
34 : Returns the pulsed source settings:
PT hold time , pulse width [, pulse period [, trig delay ]]
[;PV chnum , output range , base voltage , pulse voltage [, Icomp ]] or
[;PI chnum , output range , base current , pulse current [, Vcomp ]]
[;PWV chnum , mode , range , base , start , stop , nop [, Icomp ]] or
[;PWI chnum , mode , range , base , start , stop , nop [, Vcomp ]]<CR/LF^EOI>
35 to 36 : Not used.