![Keysight Technologies E5260 Series Programming Manual Download Page 19](http://html1.mh-extra.com/html/keysight-technologies/e5260-series/e5260-series_programming-manual_1961978019.webp)
Keysight E5260/E5270 Programming Guide, Edition 4
1- 7
Programming Basics
Getting Started
To Select the Measurement Mode
The E5260/E5270 provides the following measurement modes. To select the
measurement mode, send the MM command.
In the table, Mode No. means a command parameter of the MM command.
Syntax
MM Mode#,Ch#[,Ch#] ...
where, Mode# specifies the Mode No., and Ch# specifies the measurement channel.
The available number of measurement channels depends on the measurement mode.
For details, refer to
Example
OUTPUT @E5270;"MM 2,1"
This example sets the staircase sweep measurement, and assigns channel 1 (the
module installed in slot 1 of the E5260/E5270) as the measurement channel.
NOTE
The Mode No. is not assigned for the high speed spot measurement. Refer to
Perform High Speed Spot Measurement” on page 1-18
. The high speed spot
measurement does not need the MM command.
For the source output commands available for each measurement mode, see
.
Measurement Mode
Mode No.
Spot Measurement
1
Staircase Sweep Measurement
2
Pulsed Spot Measurement
3
Pulsed Sweep Measurement
4
Staircase Sweep with Pulsed Bias Measurement
5
Quasi-Pulsed Spot Measurement
9
Linear Search Measurement
14
Binary Search Measurement
15
Multi Channel Sweep Measurement
16
High Speed Spot Measurement
NA
Summary of Contents for E5260 Series
