Keysight Technologies E5260 Series, Programming Manual

Page: 71 / 350

Keysight E5260/E5270 Programming Guide, Edition 4 2- 9
Remote Mode Functions
Measurement Modes
5. After measurement, the sweep source waits for the rest of the step delay time if
it is set, and the sweep source changes the output value.
6. The E5260/E5270 repeats 4 and 5 for all sweep steps.
7. After the sweep measurement, the sweep sources force the start or stop value, as
specified by the WM command, and keep it.
For 0 V output, enter the DZ command that is used to memorize the present
settings of the channel and change the output to 0 V.
NOTE The WT command sets the hold time, delay time, and step delay time. The WM
command sets the automatic abort function and the output after measurement. The
WV/WI command sets the output of the first sweep source, and the WNX command
sets the output of the
n th ( n =2 to 8) sweep source. The start and stop values must
have the same polarity for log sweep.
To Stop Sweep
Output
An automatic abort function is available. Refer to “Automatic abort Function” on
page 2-23 .
Even if the automatic abort function is disabled, the E5260/E5270 automatically
stops measurement if power compliance is enabled for the sweep source and the
power compliance or an automatic abort condition is detected.