![background image](http://html.mh-extra.com/html/hyundai/hx140l/hx140l_manual_2196330370.webp)
5-43
J1939 Code
Description
Effect and Action
2882-2
Engine Alternate Rating Select :
Erratic, Intermittent, or Incorrect
The Electronic Control Module (ECM) detects a
combination of switch positions for the mode switches that
has not been defi ned.
If equipped, the warning lamp will come on and the ECM
will log the diagnostic.
The ECM will return the engine to the last good mode
selection or setting.
The engine will start and the engine will default to the
previous mode selection.
The engine may operate at reduced speed or reduced
power depending on the mode that is selected.
Mode Selection Circuit - Test
2970-2
Accelerator Pedal 2 Low Idle Switch :
Erratic, Intermittent, or Incorrect
The EIectronic Control Module (ECM) detects the following
condition:
The signal from the Idle Validation Switch (IVS) is invalid.
If equipped, the warning light will come on. The ECM will
log the diagnostic code.
Idle Validation Switch Circuit - Test
3031-7
Aftertreatment #1 DEF/AdBlue®
Tank Temperature : Not Responding
Properly
DEF/AdBlue® Tank Temperature Is Low
3031-12
Aftertreatment #1 DEF/AdBlue® Tank
Temperature : Failure
The ECM detects a failure of the temperature sensor.
The code is logged.
DEF/AdBlue® Tank Sensor - Test
3031-16
Aftertreatment #1 DEF/AdBlue®
Tank Temperature : High - moderate
Severity (2)
The temperature of the Diesel Exhaust Fluid (DEF) in the
DEF tank has exceeded the parameter programmed in the
ECM.
The code is logged.
The engine is derated.
DEF/AdBlue® Tank Temperature Is High
3031-18
Aftertreatment #1 DEF/AdBlue®
Tank Temperature : Low - moderate
Severity (2)
The temperature of the Diesel Exhaust Fluid (DEF) in the
DEF tank is below the parameter programmed in the ECM
after a heat cycle.
The code is logged.
The engine is derated.
DEF/AdBlue® Tank Temperature Is Low
3216-5
Aftertreatment #1 Intake NOx :
Current Below Normal
The ECM detects current that is below the acceptable
value.
Electrical Power Supply -Test
3216-6
Aftertreatment #1 Intake NOx :
Current Above Normal
The ECM detects current that is above the acceptable
value.
Electrical Power Supply -Test
3216-7
Aftertreatment #1 Intake NOx : Not
Responding Properly
The engine out NOx level is not responding as expected.
The code is logged.
NOx Sensor - Test
3216-11
Aftertreatment #1 Intake NOx : Other
Failure Mode
The NOx sensor cannot reach the correct operating
temperature in the defi ned time period.
Sensor (Data Link Type) - Test
侍#
Some fault codes are not applied to this machine.
Summary of Contents for HX140L
