Hyundai HX140L, Manual

Page: 373 / 819

5-46
J1939 Code Description Effect and Action
3361-5
Aftertreatment #1 DEF/AdBlue®
Dosing Unit : Current Below Normal The ECM detects the following conditions:
A low current condition in the output from the DCU to the
solenoid in the DEF.
There are no active 168 diagnostic codes.
The warning lamp will come on. The diagnostic code will be
logged.
Solenoid Valve - Test (Solenoid Valves that Connect to the
Dosing control Unit (DUC))
3361-6
Aftertreatment #1 DEF/AdBlue®
Dosing Unit : Current Above Normal The ECM detects the following conditions:
A high current condition in the output from the DCU to the
solenoid in the DEF.
There are no active 168 diagnostic codes.
The warning lamp will come on. The diagnostic code will be
logged.
Solenoid Valve - Test (Solenoid Valves that Connect to the
Dosing control Unit (DUC))
3361-7
Aftertreatment #1 DEF/AdBlue®
Dosing Unit : Not Responding
Property
DEF/AdBlue® Module Does Not Respond
3363-5
Aftertreatment #1 DEF/AdBlue® Tank
Heater : Current Below Normal The ECM detects the following conditions:
A low current condition in the output from the DCU to the
solenoid in the DEF.
There are no active 168 diagnostic codes.
The warning lamp will come on. The diagnostic code will be
logged.
Solenoid Valve - Test (Solenoid Valves that Connect to the
Dosing control Unit (DUC))
3363-6
Aftertreatment #1 DEF/AdBlue® Tank
Heater : Current Above Normal The ECM detects the following conditions:
A high current condition in the output from the DCU to the
solenoid in the DEF.
There are no active 168 diagnostic codes.
The warning lamp will come on. The diagnostic code will be
logged.
Solenoid Valve - Test (Solenoid Valves that Connect to the
Dosing control Unit (DUC))
3509-3
Sensor Supply Voltage 1 : Voltage
Above Normal The Electronic Control Module (ECM) detects the following
conditions:
The 5 VDC supply for the sensors is greater than 5.16 VDC
for more than one second.
The ECM has been powered for at least 3 seconds.
Diagnostic code 168-4 is not active.
The warning lamp will come on. The ECM sets all the
sensors on the 5 VDC circuit to the default values.
The engine will be derated.
5 V Sensor Supply Circuit - Test
侍#
Some fault codes are not applied to this machine.