![background image](http://html.mh-extra.com/html/hyundai/hx140l/hx140l_manual_2196330388.webp)
5-56
EPPR VALVE CHECK PROCEDURE
Check electric current value at EPPR valve
Disconnect connector CN-75 from EPPR
valve.
Insert the adapter to CN-75 and install
multimeter as figure.
Start engine.
Set S-mode and cancel auto decel mode.
Position the multimodal dial at 10.
If rpm display show approx 1750
佳
50 rpm
check electric current at bucket circuit
relief position.
Check electric current at bucket circuit
relief position.
Check pressure at EPPR valve
Remove plug and connect pressure
gauge as figure.
余
Gauge capacity : 0 to 50 kgf/cm
2
(0 to 725 psi)
Start engine.
Set S-mode and cancel auto decel
mode.
Position the multimodal dial at 10.
If tachometer show approx 1750
佳
50
rpm check pressure at relief position of
bucket circuit by operating bucket control
lever.
If pressure is not correct, adjust it.
After adjust, test the machine.
Multimeter
CN-75
EPPR valve
Main pump
Adapter(P/no.:21Q6-50410)
Valve casing
Main pump
Pressure adjusting
screw locknut
Valve casing
CN-75
EPPR valve
Pilot pressure
supply line
刮
刯
到
刱
刲
刳
刴
Spec : 100~700 mA
Spec : 2~25 kgf/cm
2
(30~350 psi)
14095MS21
14095MS22
4)
(1)
刮
刯
到
刱
刲
刳
刴
(2)
Summary of Contents for HX140L
