Hyundai HX140L, Manual

Page: 574 / 819

7-26
5. RCV LEVER
Maintenance
check item
Criteria Remark
Leakage The valve is to be replaced when the leakage becomes
more than 1000 cc/m at neutral handle position, or more
than 2000 cc/m during operation.
Conditions :
Primary pressure : 40 kgf/cm
2
Oil viscosity : 23 cSt
Spool This is to be replaced when the sliding surface has worn
more than 10
Ɇ
m,
G
compared with the non-sliding
surface.
The leakage at the left condition is
estimated to be nearly equal to the
above leakage.
Push rod
This is to be replaced when the top end has worn more
than 1mm.
Play at operating
section
The pin, shaft, and joint of the operating section are to
be replaced when their plays become more than 2 mm
due to wears or so on.
When a play is due to looseness of a
tightened section, adjust it.
Operation stability When abnormal noises, hunting, primary pressure drop,
etc. are generated during operation, and these cannot
be remedied, referring to section 6 troubleshooting,
replace the related parts.
Notes 1. It is desirable to replace seal materials, such as O-rings, every disassembling. However,
they may be reused, after being confirmed to be free of damage.
Þ
7
1 mm