Hyundai HX140L, Manual

Page: 353 / 819

5-26
J1939 Code Description Effect and Action
102-16
Engine Intake Manifold #1 Pressure :
High - moderate severity (2) This pressure is a variable value that is calculated by the
ECM. The resulting value is dependent on the operating
conditions of the engine.
Intake Manifold Air Pressure Is High
102-18
Engine Intake Manifold #1 Pressure :
Low - moderate severity (2) This pressure is a variable value that is calculated by the
ECM. The resulting value is dependent on the operating
conditions of the engine.
Intake Manifold Air Pressure Is Low
105-0
Engine Intake Manifold #1
Temperature : High - most severe (3) The engine has been running for 3 minutes.
No other 105 (172) codes are active.
168 codes are not active.
Code 412-16 (E1092 (2)) is not active.
The intake manifold air temperature exceeds the value that
is programmed into the ECM for 8 seconds. The engine will
be shut down. The code is logged.
This code will be reset when the temperature is less than
124
佾
(255
俈
) for 20 seconds.
Intake Manifold Air Temperature Is High
105-3
Engine Intake Manifold #1
Temperature : Voltage Above Normal The Electronic Control Module (ECM) detects the following
conditions:
The signal voltage from the intake manifold air temperature
sensor is greater than 4.95 VDC for more than 8 seconds.
Engine, coolant temperature is above - 10
佾
(15.0
俈
).
The ECM will use the default value of 70
佾
(158
俈
) for
the intake manifold air temperature “Voltage High" will
be displayed next to the status for “Intake Manifold Air
Temperature" on the electronic service tool.
The engine may show the following symptoms.
Poor stability
Poor cold running
Poor acceleration under load
White smoke
Engine Temperature Sensor Open or Short Circuit - Test
(Passive Sensors)
105-4
Engine Intake Manifold #1
Temperature : Voltage Below Normal The ECM detects the following conditions
The signal voltage from the intake manifold air temperature
sensor is less than 0.2 VDC for more than 8 seconds.
The ECM will use the default value of 70
佾
(158
俈
) for
the intake manifold air temperature “Voltage High" will
be displayed next to the status for “Intake Manifold Air
Temperature" on the electronic service tool.
The engine may show the following symptoms.
Poor stability
Poor cold running
Poor acceleration under load
White smoke
Engine Temperature Sensor Open or Short Circuit - Test
(Passive Sensors)
侍#
Some fault codes are not applied to this machine.