![background image](http://html.mh-extra.com/html/hyundai/hx140l/hx140l_manual_2196330598.webp)
8-14
8-14
If necessary, remove stopper (L, 534),
stopper (S, 535), servo piston (532) and
tilting pin (531) from pump casing (271),
and needle bearing (124) and splined
coupling (114) from valve block (312).
In removing tilting pin, use a protector to
prevent pin head from being damaged.
Since loctite is applied to fitting areas of
tilting pin and servo piston, take care not
to damage servo piston.
Do not remove needle bearing as far as
possible, except when it is considered to
be out of its life span.
Do not loosen hexagon nuts of valve
block and swash plate support.
If loosened, flow setting will be changed.
(14)
侍
侍
侍
侍
Remove valve plates (313, 314) from
valve block (312).
These may be removed in work (6).
(13)
侍
Tapping lightly shaft ends of drive shafts
(111, 113) with plastic hammer, take out
drive shafts from swash plate supports.
(12)
(210-7) MP07
(210-7) MP08
Summary of Contents for HX140L
