5-41
J1939 Code
Description
Effect and Action
1188-6
Engine Turbocharger 1 Wastegate
Drive : Current
Above Normal
The ECM detects the following conditions:
A high current condition in the output from the ECM to the
solenoid in the wastegate regulator.
There are no active 168 diagnostic codes.
The ECM has been powered for at least 2 seconds.
The warning lamp will come on once the diagnostic code
has been active for 30 seconds. The diagnostic code will be
logged.
The engine will be derated while this diagnostic code is
active. After the engine derate has been activated, the
electronic service tool will indicate “Turbo Protection Derate
Active".
This diagnostic code detects a fault in the circuit for the
wastegate regulator.
This fault is most likely to be caused by a high side short to
ground or a low side short to power.
Solenoid Valve - Test
1196-9
Anti-theft Component Status States :
Abnormal
Update Rate
Data Link Circuit - Test
1235-9
J1939 Network #3 : Abnormal Update
Rate
The Pump and Electronics Unit (PEU), the ammonia
sensor, the soot
sensor, or a NOx sensor has incorrectly stopped or started
transmitting
a data request This diagnostic code applies to the CAN C
datalink.
The ECM will log the diagnostic code.
CAN Data Link - Test
1235-14
J1939 Network #3 : Special
Instruction
The data received from the CAN C data bus is not in the
correct format.
The code is logged.
Data Link Confi guration Status - Test
1239-0
Engine Fuel Leakage 1: High - most
severe (3)
3509-XX or 262-XX codes are not active.
3510-XX or 2131-XX codes are not active.
There is a probable fuelleak from the high-pressure fuel
system. The amount of leakage is a calculated parameter.
The code is logged.
The engine will shut down.
Fuel Rail Pressure Problem
1761-1
Aftertreatment #1 DEF/AdBlue® Tank
Volume : Low - most severe (3)
The DEF tank is 0%.
Tank Level : Low - most severe (3) The Emissions System
Malfunction lamp is on and the Action lamp fl ashes.
The code is logged.
The engine may shut down.
DEF/AdBlue® Tank Level Is Low
1761-12
Aftertreatment #1 DEF/AdBlue® Tank
Volume : Failure
The ECM detects a failure of the level sensor.
The code is logged.
DEF/AdBlue® Tank Sensor - Test
侍#
Some fault codes are not applied to this machine.
Summary of Contents for HX140L
