Hioki ST5540, Instruction Manual, Page: 88 / 326

6.2 Making automatic measurements
82
Power supply polarity and equipment status are automatically switched during measurements.
The user can select the measurement items that should be switched and set the measurement time.
6.2 Making automatic measurements
becomes available in the measurement screen
that appears after settings are completed.
Press to automatically start measurements.
Only is available during automatic measurements.
An intermittent beep sound during status measurements. No
beep sound is output at this time when the beep setting for
"key input" is turned off.
See "7.13 Setting the Beep Sound" (p. 135)
When measurements end, print or save the measurements as
required.
On the Automatic measurement result screen, press to print the
measurement data.
See "6.6 Printing Measurement Data (as required)" (p. 108)
On the Automatic measurement result screen, press to store
the measurement data in internal memory.
See "6.4 Saving Measurement Data (As required)" (p. 102)
To repeat measurements, press .
Setup
Starting measurements
During measurements
When measurements end
Set up the instrument.
See "Chapter 4 Settings" (p. 47)
Pre-test inspection
Perform a pre-test inspection.
See "3.5 Pre-Test Inspection" (p. 41)
If measurement values do not stabilize due to abrupt input fluctuations in the
auto range during automatic measurements, measurements are terminated and
no further measurements are made.