GK600 User Manual
Chapter 4 Operation and Run Instructions
- 65 -
Flow chart of user password setting:
Fig. 4-11 Flow chart of user password setting
ATTENTION:
User's password is successfully set when step 8 finished, but will not take effect until the
completion of step 9.
Password authentication
In non-parameter edit status, press
to enter first-tier display A0-00, then press
to enter second-tier display 0.0.0.0. Control panel will implement the display of
other parameters only when correct password entered.
Clear password
After successful password authentication, it will access password setting code A0-00.
Password can be cleared by writing value 0000 into A0-00 twice.
Example of parameter setting
Example 1
: modify upper limit frequency from 600Hz to 50Hz (change b0-09 from
600.00 to 50.00)
1) In non-parameter edit status, press
to display current parameter A0-00;
2) Press
to move flashing digit to modification bit (A flashes);
3) Press
once to change "A" to "b";
4) Press
to move flashing to modification bit (0 in ones place flashing);
5) Press
nine times to change "0" to "9";
6) Press
to view the parameter value (600.00) of b0-09;
7) Press
to move flashing digit to modification digit (6 flashing);
8) Press
six times to change "6" to "0";
9) Press
once to move flashing digit rightwards by one bit;
放弃修改
50.00
50.00
0.0.0.
6
0.0.0.
0
A0-00
50.00
ENT
ENT
▲
>>
0
.0.0.6
1
.0.0.6
A0-0
1
A0-00
ENT
▲
▼
ENT
0.0.0.
0
0.0.0.
6
0
.0.0.6
1
.0.0.6
A0-01
50.00
A0-00
ESC
▲
>>
▲
ENT
ESC
Escape modification
