Chapter 4 Operation and Run Instructions GK600 User Manual
- 58 -
Fig. 4-3 Run parameter display status (Displaying run frequency – 50.00Hz)
Stop status will be enabled immediately upon receipt of stop command in such a status. Press
to get into parameter edit status (get into password authentication status if parameter
under password protection). Directly get into frequency modification status when receiving
UP/DOWN command from terminal, or pressing
or
. Switch to fault alarm display
status once a fault occurs or an alarm is given.
4.1.3.3 Fault Alarm Display Status
In case a fault occurs or an alarm is given, the drive will get into fault or alarm display status.
Fig. 4-4 Fault or alarm display status (CCL: Contactor act fault)
In such a status, the drive gets into stop status upon receipt of pressing
, and would get
into parameter edit status when receiving pressing
command again (if parameter is
under password protection, the drive would get into password authentication status). Directly
get into frequency modification status when receiving UP/DOWN command from terminal, or
pressing
or
.
