C h a p t e r 1 0 H i g h - s p e e d C o u n t e r s a n d H i g h - s p e e d Ti m e r s
Function block
10.2
High-speed Timers
The setting of high-speed counters is described below.
Mode of measuring time
Number Counter
Device
Setting value
External
signal
Storage
device
0 C200
K1SM200
X0.0
C201
1 C204
K1SM204
X0.1
C205
2 C208
K1SM208
X0.2
C209
3 C212
K1SM212
Bit3
Bit2
Bit1
Bit0
-
Enabling
the timer
-
Selecting
a mode
Bit 2: Enabling a timer
Bit 0: (1) 0: General mode (The
interval between the rising edge
of a pulse and the falling edge of
the pulse is measured.)
(2) 1: Cyclic mode (The interval
between the rising edge of a
pulse and the rising edge of the
next pulse is measured.)
X0.3 C213
Example 1: Using C20s in general mode
1. Users have to select the general mode, and enable the timer, that is, they have to write K4 into
K1SM208.
2. C208 is enabled. The interval between the rising edge of a pulse received through X0.2 and the
falling edge of the pulse is measured. The interval is written into C209. (Unit: 0.01
microseconds)
t1
t2
X0.2
t
C209
C209
General mode
Unit: 0.01
μ
s
1 0 - 5
Summary of Contents for AH500
