DMS-R-IM
Safety
April 7, 2021
Digital Modular System - Rinse
1-13
1.10
Electrical Hazards
Electrical Hazard:
Hazardous voltage. May cause electrical
shock or burn. Refer to electrical drawing for more detail.
Disconnect and lockout tag-out system. Wait for
at least 15
minutes
after main supply is disconnected prior to servicing
this system.
WARNING
Power to this system is provided by
DMS-1218: 240VAC / 3-phase / 60Hz / 16Amp
DMS-1826: 240VAC / 3-phase / 60Hz / 31Amp
Disconnect and lockout tag out (LOTO) system prior to
servicing.
General Electrical Safety:
Only trained and certified personnel should remove covers.
Ensure that only trained personnel, familiar with electrical hazards, have
access to the inside of the system.
Follow accepted working procedures and code of practice when working on
electrical components.
Follow the requirements of the electrical safety code for the site where the
system is installed.
Read the operating instructions of the system before commencing any
servicing.
Never wear rings, bracelets or other jewelry when working around electrical
circuits.
Never work on electrical equipment alone. Always have a colleague nearby.
Isolate the main power input at the circuit breaker, lock it in the
OFF
position and attach a notice to the circuit breaker before replacing fuses or
exchanging printed circuit boards (PCB).
Never operate the system if any main power cable is frayed or damaged.
Never operate the system in production with safety covers removed.
Never assume the polarities of cabling or replacement components.
