DMS-R-IM
Appendix
April 7, 2021
Digital Modular System - Rinse
9-20
Step
Description
5
While pressing the “SET POINT” switch, turn the Set Point #1
adjustment screw (See Figure V.A.1 below) until the desired set point
value is indicated on the display.
6
Once done, release “SET POINT” switch.
7
Close the resistivity monitor’s front panel properly. Fasten the four (4)
screws.
8
The red LED indicator light is ON when water’s resistivity reading is
low or below resistivity set point. May be reversed if desired.
9
The green LED indicator light is ON when water’s resistivity reading
is high or above resistivity set point. May be reversed if desired.
Note
: “Optional item” (Only applicable when this feature is purchased)
