![background image](http://html.mh-extra.com/html/conair/htc-120/htc-120_user-manual_2649067279.webp)
Replacing the Regeneration Heater
(W3200 - 5000)
(continued)
6
Loosen the two (2) lower clamps that secure the regeneration manifold
and tubing to the desiccant wheel bracket.
Remove the regeneration
manifold and the tubing that is attached to the bottom of the manifold. Then
remove the tubing from the regeneration blower outlet and check for loose
particles within the tubing, clean as necessary. Reverse this procedure to
reinstall the regeneration manifold and tubing.
7
Slide the insulation off the heater tube(s), or make a cut down the entire
length of the insulation sleeve to aid removal.
8
Compare the markings on the outside of the regeneration heater tube to
ensure the new one has the same voltage and kW ratings as the original
heater tube.
This information is on the end nearest the wires.
9
Slide the original insulation over the new heater,
or if the insulation was cut
for removal, wrap the cut insulation sleeve around the new heater tube and
secure it with heat tape.
10
Make sure the cable end of the new heater tube is to the bottom, then
reconnect the hoses to the top and bottom of the heater tube
and resecure
with pressure clamps that were removed in Step 5.
11
Connect the high temperature switch cable to the quick disconnect.
12
Route the heater power wires into the junction box and connect them to
the supply leads from the control box.
Refer to the wiring diagram for
specific connection information.
13
To ensure all connections are correct, measure the resistance as in Step 3.
You should measure the readings as noted for a good heater.
14
Close the side panel of the dryer.
15
Connect the dryer to power and turn it on.
Verify the regeneration tempera-
ture achieves the setpoint.
M a i n t e n a n c e l
5-29
5
M
ai
n
te
n
an
ce
Summary of Contents for HTC 120
