![background image](http://html.mh-extra.com/html/conair/htc-120/htc-120_user-manual_2649067073.webp)
Installing the Dwyer 641 Air
Velocity Transmitter
(continued)
3
Screw the compression fitting into the customer-supplied pipe.
4
Orient the air velocity probe so that the flow direction arrow stamped on
the NUT used to secure the transmitter is pointing in the direction of the
air flow.
The arrow is located on the nut below the conduit bodies.
5
Center in pipe.
This will allow you to adjust the air velocity probe in the cen-
ter of the air stream.
Air Flow Direction
Arrows Located
on the Nut
3
In
st
al
la
tio
n
I n s t a l l a t i o n - P i p i n g / H o s e s l
3-43
NOTE:
Refer to Dwyer 641
Instructions found in the
Appendix of this manual.
✐
Summary of Contents for HTC 120
