Conair HTC 120, User Manual

Page: 206 / 330

4-64 l O p e r a t i o n
Adjusting the Energ ySmart Dr yer
System
(continued)
Without OptiMizer
TM
Mode
When the processing machine is turned off and material is not being taken away
from the drying hopper, the material in the hopper will settle significantly over
time. You may see several receiver dumps into the top of the hopper based on
material settling. This settling of material will make it more difficult for air to
flow through the hopper and you will see this by an increase in blower speed to
maintain the same air flow setpoint (if in Auto). This is normal and will change
back once the processing machine begins to take material from the hopper
again. If in Manual, you may experience a reduction in airflow.
Temperature - Electric (Hopper Temperature Controllers [HTCs])
There is one heater for the dry air loop supplied with the EnergySmart™ Dryer
System.
It cost more energy to run at higher setpoint temperatures. The on time value
shown on the screen above
(See System Overview screen (Screen 2)) is a
percentage of maximum heating, 100% being that the heater is working at
maximum capacity.
(continued)